EasyManuals Logo

RCA PRO-SW220P User Manual

RCA PRO-SW220P
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
1. Connect the PRO-SW220P’s
LOW
LEVEL INPUT
jacks to the amplifier/
receiver’s line sub out or pre out jacks
(or TV’s audio line out jacks).
2. Connect your satellite speakers (if
any) to the amplifier’s or receiver’s
output terminals as they would
normally be connected.
Notes:
On some receivers/amplifiers, the
subwoofer out is a single jack. Use a
single phono cable (not supplied) to
connect the subwoofer jack to the
L
input on the PRO-SW220P.
When connecting to a TV, we
recommend using variable line output
jacks, which will allow the PRO-
SW220P’s volume to change with the
TV’s volume. Refer to your TV owner’s
manual. Also, you can connect to the
TV line out and then adjust the TV
volume up or down. If the subwoofer
volume changes with the TV volume,
then the TV line out is variable.
C
CC
Co
oo
on
nn
nn
nn
ne
ee
ec
cc
ct
tt
ti
ii
in
nn
ng
g g
g t
tt
to
o o
o S
SS
Sp
pp
pea
eaea
eak
kk
ke
ee
er
r r
r
T
TT
Te
ee
er
rr
rm
mm
mi
ii
in
nn
na
aa
al
ll
ls
ss
s
Connect the amplifier/receiver’s speaker
output terminals to the PRO-SW220P’s
HIGH LEVEL INPUT
speaker terminals. Be
sure to connect the terminals in phase,
connecting positive (+) to positive and
negative (–) to negative. Wiring the
subwoofer with + to – causes reduced bass
performance. To match the subwoofer’s
polarity with your system’s polarity and
receive full bass response, slide the
PHASE
switch to
REV
or
NOM
. Choose
the setting that provides the greatest bass
output.
C
CC
Co
oo
on
nn
nn
nn
ne
ee
ec
cc
ct
tt
ti
ii
in
nn
ng
g g
g S
SS
Sp
pp
peake
eakeeake
eaker
rr
rs
ss
s
You can connect your left and right
speakers to your amplifier/receiver (as
shown in “Connecting to Subwoofer Out
or Pre Out Terminals”), or to the PRO-
SW-220P’s
HIGH LEVEL OUTPUT
speaker terminals (as shown above).
N
NN
No
oo
ot
tt
te
ee
e:
::
: The High Level Output is a pass-
through, and only works when using a
High Level Input.
However, if you use MEGACABLE or
any other high-quality, low-gauge speaker
wire, the terminals will be too small to
accommodate the wires.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RCA PRO-SW220P and is the answer not in the manual?

RCA PRO-SW220P Specifications

General IconGeneral
BrandRCA
ModelPRO-SW220P
CategorySubwoofer
LanguageEnglish

Related product manuals