11
ENGLISH
Testing the Code for Maximum Functionality
1. Try a variety of the device’s functions with the
remote. If some features of your devices don’t
work, go to the next step to try a different code.
2. Repeat the Manual Code Search and Entry
Method from the beginning. When the device
turns off for the fi rst time, don’t press the OK/
ENTER key, which would store the same code.
Instead, with the unit now off, continue to press
the SKIP FWD key repeatedly until the unit turns
back on.
3. Once the unit turns back on, you have found
another code that operates the device. Press the
OK/ENTER key.
4. Test the key’s functionality again by trying a
variety of functions. If the code controls the
majority of the device’s functions, programming
is complete. If the code stored does not give
maximum functionality, try another code.
NOTES: Throughout the programming of each
key, keep the remote pointed at the device you
are programming the remote to control.
Test the remote with the device to make sure the
device key is programmed with the correct code
for maximum functionality. If some features don’t
work, try a different code. See the “Testing the
Code for Maximum Functionality” section below
for more information.
During the Manual Code Search, the remote
ignores keypresses that aren’t part of the search.
The search times out after two minutes (the
POWER key blinks four times and the last
programmed code under that device key is
retained).
The POWER key blinks four times when the
remote has gone through all the codes. The
remote exits the Manual Code Search. If your
device hasn’t turned off yet, try a different search
method.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
