nCr 0≤ n < 1 x 10
10
, 0 ≤ r ≤ n (n, r are integers)
1≤ n!/r!< 1x10
100
or 1≤ n!/(n–r)!< 1x10
100
POL(x,y) |x|, |y| ≤ 9.999999999x10
99
≤ 9.999999999x10
99
REC(r,θ) 0≤ r ≤9.999999999x10
99
θ: same as sinx
DMS(° ’ ”) |a|, b, c < 1 x 10
100
0 ≤ b, c
DMS ← ° ’ ” |x| < 1 x 10
100
Decimal ↔ Sexagesimal Conversions
0°0’0” ≤ |x| ≤ 9999999°59’59”
x
y
x>0 : –1x10
100
<ylogx<100
x=0 : y>0
x<0 : y=n,
(m, n are integers)
However: –1x10
100
< ylog|x|<100
x
√y y>0 : x≠0, –1 x 10
100
<1/x logy<100
y=0 : x>0
y<0 : x=2n+1,
(m≠0; m, n are integers)
However: –1x10
100
<1/x log|y|<100
a
b
/c
Total of integer, numerator, and denominator must be 10 digits
or less (including division marks).
RanInt(a,b) a<b; |a|, |b|< 1 x 10
10
, b–a< 1 x 10
10
Error messages
An error message appears on the display if the calculations cannot continue in
the following cases:
Math ERROR
(1) If dividing by zero.
(2) If inserting values that exceed the maximum range
of the calculator for calculation.
(3) If the result of the calculated function exceeds
capacity.
(4) If the entered function argument is out of a valid range.
Syntax ERROR
(1) Incorrect submission, uncomplying syntax.
(2) If an uncomplying argument has been entered in
the order.
Stack ERROR
(1) If the numerical value or operand value exceeded
a permitted range (stack overow).
(2) If the
[(]
button is used more than 25x in one expre-
ssion in the linear mode.
Argument ERROR
(1) There is a problem in the function argument that you
want to calculate.
Dimension ERROR
(1) Matrix/vectors were entered without specifying
dimension.
12–EN
To Next Page
Loading...
