BEFORE YOUR USE
CONNECT AIR HOSES
Connect the set of hoses to the
cuffs, starting with the dark gray
connector,
and then plugging the other gray
connectors onto the appropriate
counterparts.
NOTE: We recommend that you
do not detach the connectors
afterward.
TIGHTENING LEG CUFFS
To prevent contamination, we recommend
wearing leggings or sweatpants when using the
device. Empty your pockets before application!
NOTE: In general, the boots should be pulled up as
far as possible. Only the tips of the toes (not the
toes!) should stick out at the end. This way you can
ensure that your entire legs benefit optimally from
the recovery application.
The zippers on the cuffs must be completely
closed to avoid the cuffs from suddenly splitting
open and causing possible damage.
After plugging it into the power plug, putting on
the cuffs, and tightening the zipper, the Reboots
application controls on the control unit can be
adjusted. You will find more information on the
following pages.
DEVICE SET-UP
Ensure that the device is securely placed.
Also make sure that the device is free
standing and not covered by a blanket, or
similar. Do not use the device in damp
rooms or those with high humidity, such as
in saunas or bathrooms.
NOTE: Always
make sure that the
hoses are not
kinked, and that
you are not sitting
on the hoses.
31
To Next Page
Loading...