RW8D2/4,RW10D2/4,RW12D2/4
SUBWOOFER SPEAKER SYSTEM 8/10/12-INCH
BILL OF MATERIAL
• Check that the installation site has sufficient air exchange on both sides of
the speakers before drilling holes.
• Check that nothing interferes with the normal operation of the cone, other
wise the cone will be damaged.
• Use a utility knife to cut off excess pieces of fabric near the hole where the
speaker will be installed before starting drilling.
• Use a grommet for the speaker wires (not included) when pulling through
sheet metal, otherwise the wire may be damaged by the metal edges of the
hole.
Subwoofer - 1 pc
Instruction - 1 pc
Mounting screw pack - 8 Pair
EXAMPLES OF CONNECTING SPEAKERS
Your subwoofer speakers have a dual voice coil and 2Ω/4Ω impedance.You need
to know the maximum power of your amplifier to optimize your sound,
You can vary the impedance parameter by connecting the woofer acoustics: in series,
in parallel or mixed. Please select a suitable woofer speaker connection scheme
depending on the number of speakers to be connected through the speaker system
and the stability of the amplifier impedance. The most important thing when
connecting speakers is to make the connection so that none of the speakers are
overloaded. Overload threatens to damage the speaker. It is important to understand
that the speaker can be powered either less or equal to the rated power for which it is
designed. Otherwise, any speaker will be damaged due to overload. Before
connecting the speakers, you need to determine their nominal power (W), the active
resistance of the voice coil (Ohm), which are indicated on the magnet or in the
technical specifications in the attached instructions.
2
To Next Page
Loading...