Check the belt is tightened correctly to prevent the base from
moving and then close the other belt guide.
Press the lever to complete the tightening operation. It will
click when fastened.
Fit the RC/RCS groupe 0 into the fasteners of the base using
the rods situated on the lower part. First insert the front part
(movement 1) and then the rear part (movement 2). When
pressed, it will click when fastened correctly.
To remove the RC/RCS groupe 0, pull the front handle with
one hand and with the other hand remove it from the base.
Set the RC/RCS groupe 0 handle to the forward position. Pass
the chest strap through the upper belt guide on the side of the
retractor.
• Check that the strap does not go underneath the backrest
adjusting mechanism.
• Bear in mind the baby’s weight when choosing the position of
the backrest in the vehicle:
A: up to 5 kg.
B: up to 5 kg.
C: CAN NOT BE USED
D: from 5 to 10 kg.
IMPORTANT: Adjust the seat belt tension every time you
change the position of the backrest.
To Next Page
Loading...