7
ENG
Ensure that you have the correct number of people to lift the aquarium
according to its weight and size.
Ensure that anyone lifting the aquarium is physically suitable for such an
operation and has been instructed in the correct methods of lifting heavy
objects.
Once the aquarium is correctly aligned with the cabinet, check that the
cabinet has not moved. If necessary readjust the position of the cabinet.
For units with adjustable legs: Using a spirit level on the top surface of the
glass tank, adjust the height of the legs to level the aquarium. Make sure
that all legs are touching the floor.
Before placing the glass sump in the cabinet make sure that the cabinet
doors are correctly aligned (see instructions in the cabinet assembly
manual). With the doors properly aligned, rotate the front section of the
push opener to the correct extension so that the doors will pop open when
pushed.
Overflow box pipes: Make sure that that the O-rings are in position on the
threaded connectors before assembly. To ensure correct assembly, firmly
hold the threaded connectors from inside the cabinet and tighten well by
hand. Do not use tools. Avoid unscrewing the pipes from the overflow box
once assembled as the locking mechanism that prevents counter-rotation
will be less effective.
Sump pipes: Make sure that the O-rings are in position on the connectors
before assembly. After assembly check that the securing nut is holding the
pipe in position. Do not use tools and do not overtighten.
Overflow Box Cover: The overflow box cover reduces noise from the water
fall of the surface skimmer. If you wish to use the rear wall of the overflow
box for mounting equipment such as lighting, break out the section of the
cover as shown in the graphic manual. After breaking out the removable
section, smooth the remaining edge with a file or sandpaper.
ReefATO+: Install the ReefATO+ sensor and tube holder in the pump
chamber of the sump as instructed in the additional manual and select a
suitable place for mounting the controller and other components provided
with it.
The ReefATO+ has many smart features so it is recommended to review
the manual to properly understand how to use them.
After initial installation make sure that the Auto-fill is switched off until the
REEFER system is filled to its normal operating level with saltwater.
The REEFER G2+ systems do not include a reservoir for the top-off water.
To Next Page
Loading...
Need help?
General
