RED MOA - Page 27

27
EN
Installaon or removal
Detailed informaon demonstrang the dif-
ferent ways of installing or removing a radi-
ator heang element is available from the
manufacturer or importer (see footnotes at
the end of the manual). Below we list some
basic requirements and principles which
must be followed to ensure long term, re-
liable operaon of the product.
150°
When installing the heang element hor-
izontally, the single tube (capillary) where
the temperature sensor is located, should
be posioned to be as close to the boom
of the radiator as possible.
Before installaon or rst use:
1. Read the chapter Safety requirements
— Installaon.
2. Fit the heang element using the cor-
rect spanner (size 22).
3. The heang element must be installed
at the boom of the radiator, perpen-
dicular to the radiator pipes, while pre-
serving space for the proper circulaon
of the heang medium.
4. Use a suitable heang medium for ll-
ing the electric radiator, i.e. (water, spe-
cial products based on water and glycol
for use in central heang systems, or oil
which complies with the requirements
of the manufacturer of the radiator and
heang element).
5. Check the distances between the indi-
vidual heang element tubes and bend
if necessary.
5 mm
2-3 mm
8%
(
20°C
)