RED MOA - Page 30

30
User manual of electric heater RED MOA
Electric Heang Element
RED MOA
Turning the device on with the buon will
result in the radiator heang up to the set
temperature. Aer reaching the set temper-
ature the device will turn o and on regular-
ly in order to maintain the set temperature.
The construcon of the device as well as
the physical characteriscs of the heang
agent inside the radiator, inuence the way
in which the heat is distributed — the tem-
perature of the boom pipes on the radiator
(especially the two located at the very bot-
tom of the radiator), may be lower than the
temperature of the remaining parts of the
radiator — this is a normal phenomenon.
Temperature increase
In order to increase the temperature of the
radiator, press once or several mes as re-
quired; the correct number of diodes will
start blinking. The last blinking diode indi-
cates the set temperature, whilst the last di-
ode which shines constantly, indicates the
current temperature. The remaining diodes
will start shining constantly on reaching sub-
sequent temperature levels.
Temperature decrease
In order to decrease the temperature of the
radiator, press once or several mes as re-
quired; the corre ct number of diodes will
start blinking. The last diode, which shines
connuously, indicates the set temperature
whilst the last blinking diode indicates the
current temperature. The remaining diodes
will start fading on reaching subsequent tem-
perature levels.
An-freeze funcon
When the device is o and the temperature
surrounding the temperature sensor drops
dryer funcon
turn on/o buon
temperature regulaon