①
②
③
7 8
Daily storage
Machine cleaning
Dump dust, clean the dust collection cup and replace the cleaning filter
Disassembly of the floor brush roller
Before the use, make sure all filters and floor brushes
are installed in the correct location.
During the use
Please do not come close to the radiator.
Before the use
Cautions and product maintenance
Troubleshooting instructions
※ Product Parameter
Trouble clearing and product parameters
※
※
When the product does not work properly,
please refer to the instructions.
Fault conditions
Indicator status
flashing
Host does not turn
Electric floor brush
does not turn
Decreased suction
power
LED indicator
does not light up
when charging
Too slow to charge
Settlement Solutions
1
2
3
4
5
6
①
To prevent damage caused by collision, please move away from large and
sharp objects. Do not use it on any flammable items or liquids,
such as gasoline, cigarettes or alcohol.
For long-term storage, please keep the machine in a cool and dry place
away from direct sunlight or humidity.
Pull the button on the dust collection cup and dump the dust. Use a tool or
dry cloth to clean the dust collection cup. After the cyclone body is
removed, the filter, sponge and cyclone body can be washed in water, but
must be completely dried before use.
As shown in the picture, press the floor brush roller switch, go to remove
the roller floor brush for cleaning. For installation, please install in the
reverse order of disassembly.
Open the floor brush roller
Note
1. The indicator light flashes at the current power level when charging;
2. When fully charged, the indicator light is fully lit and goes off after
10min;
3. When the battery power is too low, the last cell indicator flashes.
1. Battery power is insufficient, please use after charging;
2. Excessive use time will cause high temperature protection, leave to
cool, then turn on again and use.
1. When it's stucked with foreign object, please continue to use after
timely cleaning foreign body;
2. Motor high temperature protection, please wait for the brush head
temperature is normal before use;
3. Electric brush head conductive contact point dirty, please wipe the
surface of the contact point with a dry and soft cloth, and then retry.
1. Dust cup dust collected full, clogged filter, please timely clean dust cup
and filter before use;
2. The ground brush head is clogged, please clean it before use.
1. Check whether the power adapter is connected well;
2. The battery is fully charged and the battery is in the hibernation state.
If the battery temperature is high or low, please wait until the battery
temperature returns to normal before charging.
Brand
Model
Power Rating
Battery Configuration
Dust Cup Capacity
Weight (Net/Gross)
Dimension
Redkey
P8
250W
Li-ion 2200mAh 22.2V
500ml
2.8kg/3.9kg
706*294*129mm
To Next Page
Loading...