6. After the setup procedure is finished (after pressing the “FINISH” button), the screen will
display the current status of your device as well as additional configuration options such as:
Programs, Timer mode and Lamp switch off
7. In the upper right corner of the screen you will find a drop-down menu icon. There you
can introduce any necessary changes or repeat the device setup procedure. It also contains
additional functions, including options for Wi-Fi network management, device network
password, which protects your device against any unauthorized remote access, Smart Reef
account management, time and date setting, language selection and the possibility to restore
your device to default settings. Moreover, the icons indicate the current status of connection
to your wireless network and to the Smart Reef system.
The symbol means that the connection is OK, while the symbol means that there is
no connection.
8. Lamp operation mode. As a default, the lamp is programmed to emit the light spectrum
corresponding to the natural day and night cycle. The user may change these parameters by
using additional functions described below:
- PROGRAMS - makes it possible to set the switch on and switch off times individually for the
lamp with the sunrise and sunset simulation. It is also possible to regulate light intensity for
individual light colors to obtain the optimum effect for your aquarium. When the parameters
are set, the lamp system informs about the current light strength and lamp operation
temperature. After setting the lamp operation parameters remember to save them by adding
To Next Page
Loading...
Need help?
General
