Installation Instructions
REESE Dual Cam HP
High-Performance Sway Control
Part Numbers:
26002
DUAL CAM HP ASSEMBLED
Equipment Required:
Wrenches: 1-1/2” Open End, ¾” Open End
Drill Bits: 7/16”, 17/32” & Center Drill (Pilot Drill)
INDEX
1. INSTALLATION & ASSEMBLY P. 2-4
2. PRE-INSTALLATION (TOW VEHICLE MAY NOT BE PRESENT) P. 4
2. INSTALLATION WITH TOW VEHICLE PRESENT P.4-5
3. TUBULAR FRAME DUAL CAM HP FRAME PLATE INSTALLATION P. 5-6
4. C-CHANNEL FRAME DUAL CAM HP FRAME PLATE INSTALLATION P. 6
5. CAM ARM ADJUSTMENT P. 7
6. BEFORE EACH TRIP & MAINTENANCE P. 7
7. NOTES P. 8
8. LIMITED LIFETIME WARRANTY P. 8
j
Qty. (2) Dual Cam HP Cam Arm Assembly
k
Qty. (2) Hanger Bracket
l
Qty. (4) ½ - 13 Thread Forming Screw*
m
Qty. (2) ½-13 X 3 ½” Square Head Bolt*
n
Qty. (6) ½-13 Hex Nut*
o
Qty. (2)
½” Lock Washer**
p
Qty. (4)
½-13 X 1 ½” Grade 5 Bolt**
Fastener Kit: 100126
Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating, or
Trailer Manufacturer’s Rating
DEALER/INSTALLER:
(1) Provide this Manual to end user
END USER:
(1) Read and follow this Manual every time you use Dual Cam HP.
(2) Save this Manual for Future Reference.
(3) Pass on copies of Manual to any other users or owner.
j
k
l*
m*
n*
WARNING:
Failure to follow all of these instructions may result in death or serious injury!
Figure 1
*For Tubular Style Frame Attachment
**Not Shown, For C-Channel Style Frame Attachment
½” Open End, ¾” Socket & Ratchet
Other: 8 – 10” C-Clamp, Tape Measure, Light Penetrant Oil
For Installation or Operation Support contact CPP Technical Service: 1-888-521-0510.
Figure 2 – Inside View of Trailer Frame
To Next Page
Need help?
General
