-12-
4. Place Slide / Film Holder Into the Scanner
The scanner supports 50x50mm mounted slides with
a thickness of up to 3.2 mm, color negative and B&W
negative films of type 135, 110 and 126.
Insert your slides into the slide holder or your negative
strips into the negative holder.
Make sure the shiny side of the film is facing upward.
Now insert the holder into the slot of the scanner from the
right side. When moving on, the holder will snap into place
with each image.
You may fine adjust the film’s position by referring the
image shown on the display.
Press the OK/( ) button to scan the image, the image is
saved into the SD Card automatically.
To Next Page
Loading...
