REFOX LM-80B - Steps for Usage

To Next Page

To Previous Page

1. Connect to the power supply, turn on the power switch, and remove

the lens cover;

2. Press the "Laser" button; (the screen of LM-80B will light up till the

button is pressed )

3. Open the software and call up the corresponding drawings;

4. Place the phone along the ﬁxed strip and turn on the Exhauster

switch;

5. Press the Focus button to automatically focus the point;

6. Click the red light to preview the target and adjust the parameters;

7. Start Marking button to start marking;

8. At the end of marking, remove the back cover glass of the phone.

(Note: If you need to use the keyboard to calibrate the red light position

or modify other settings, the login role in the upper right corner can be

switched to administrator, password:111111)

Steps for Usage