No Diving or Jumping. Observe all Safety Rules
1-5
3. Make the area flat and level
a. Replace the centre peg with a flat-topped stake, at
least 1” (25 mm) square and 6” (15 cm) long. Drive
it down flush with the ground surface.
b. Nail one end of a straight 2-by-4 (5cm x 10cm)
wood plank to the top of the stake. Use a nail long
enough to hold the end of the 2-by-4 (5cm x 10cm)
wood plank to the stake while you rotate it in a
circle. (Image 4)
c. Put a carpenter’s level on the wood plank and
swing the board in a circle to find the high and low
spots. (Image 5)
d. Remove all the high spots with a shovel, hoe or
rake. (Image 6)
B. CONT. PREPARE THE FOUNDATION OF YOUR POOL
GENERAL INSTRUCTIONS - ROUND POOLS
GROUND PREPARATION
Secon
1
4
5
6
Important Note:
Use the optical level to ensure that the ground is
perfectly flat and level.
To Next Page
Loading...