2. Security advices
It is important that you read this manual
carefully before installing and operation the
RK Mover. Please keep it handy in your
vehicle!
The person who installs the MoveControl is
responsible for the faultless and proper
installation. We recommended that you to have
the MoveControl installed by skilled staff from a
specialized workshop. The MoveControl can be
installed in front of or behind the axle.
Parts of the chassis, axle, suspension or the
brake mechanism must never be removed,
changed or affected. A perfect operation is only
guaranteed if the MoveControl is correctly
installed, if the tyre pressure is correct and if the
drive rollers are in the correct distance from the
tyres.
Reich GmbH assumes no liability for any kind of
damage that might occur to a caravan or trailer
because of the installation or the operation of the
MoveControl.
In case of any damage due to a failure of the
MoveControl, caused by a production fault, we
only compensate for the maximum acquisition
cost of the MoveControl within the guarantee
period.
We reserve the right to change the moving drive
of the MoveControl without notice, at any time.
The MoveControl is meant as a moving aid for
caravans and other trailers, to be used on
camping sites and private grounds.
It is not allowed to sell the MoveControl to the
USA or to Canada, or to use it in those country’s.
Reich GmbH reserves all rights. It is not allowed
to duplicate, save or publish, by print, photo copy,
micro film or in any way, neither electronically or
mechanically, this installation and operation
manual as well as its content without previous
written consent of Reich GmbH.
BEFORE MOVING, PLEASE CHECK THAT THE
FRICTION ROLLERS ARE ENGAGED ON TO
THE TYRE (Pic. 3.5 = ON).
ONLY IN THIS POSITION THE RANKING
PROCESS IS ALLOWED TO!
Hint:
We can accept no liability for damages that occur
through non compliance with these instrauctions.
Modifications and errors excempt.
Before you release the
friction rollers, please
ensure that your brake is
engaged to prevent your
caravan rolling away!
If you experience problems do not use the
MoveControl. Please have the device checked
at an authorized dealer.
For all installation and maintenance work you
should turn off the power supply with the isolation
switch.
Ensure that no one turns the main switch on
again and disconnect the battery (first the
negative pole).
Working with the power connected is extremely
dangerous.
Batteries have to be treated, stored or disposed of
in accordance with the manufacturers
instructions. Send old batteries to the recycling
process.
Be careful of chemical burns: Battery acid is
strongly corrosive.
Keeping children away from acid and batteries.
A solid seat of the battery has to be respected.
Following notes on the battery and checking
these regularly. Replacing or charging has to be
carried out with great care.
BEFORE TOWING THE CARAVAN, PLEASE
CHECK THAT THE FRICTION ROLLERS ARE
IN THE BACK POSITION (Pic. 3.4 = OFF).
When installing a caravan-moving
device, in principle, the ground
clearance of the caravan is reduced.
When driving or moving, please be
aware of the reduced ground
clearance (80 mm minimum - 120 mm
recommended ground clearance is
required).
GB2
English
327-130230S1 - 0902_MCC_MBA RC2_2 2 18.03.2009 14:36:36
To Next Page
Loading...
Need help?
General
