Appendix A1 - A3
LED remote control
LED basic station
LED remote control
LED basic station
A3 Maintenance
A) At least once a year please have your
MoveControl maintained and visually
inspected as described below:
- Cleaning of the complete drive unit.
- Application of suitable lubricant to all moving
parts (e.g. silicon spray).
- Check of the distance between the drive
rollers and the tyres as well as a checking the
tyre pressure.
- Visual inspection for damage of the cables
and the electrical connections.
- Check battery voltage.
B) Before moving please check if the moving
drive is free of dirt, sand and debris.
C) In case of failures or problems please contact
your supplier.
A2 Reset
The reset process is only required if the LED of
the E-box is eluminated. This is an error signal
(for example overload) - the LED is usually off.
When resetting the overload protection reverts to
its normal position.
A1 Synchronization
Following a malfunction or after exchanging an
electronic part a synchronization procedure must
be carried out. Proceed as follows and avoid
pauses of more than 2 seconds:
Turn ON handset = Double click
Reset-button = push
LED basic station Off
Turn OFF handset = single click
The reset process is complete.
Attention! If the LED does not go out after
repeating reset procedure for several times,
please contact your dealer.
The synchronization is completed.
Attention! Avoid pauses of more than 2
seconds during the synchronization,
otherwise the synchronisation has to be
restarted.
After approx. 20 seconds, the remote control will
be switched-off automatically, if there were no
entries!
If necessary turn the remote control
OFF = push one time
System ON = turn isolation switch on
Reset-button = push and hold!
Handset turn ON = Double click
Handset turn OFF = push one time
Release reset-button
On
Off
GB11
English
327-130230S1 - 0902_MCC_MBA RC2_11 11 18.03.2009 14:36:37
To Next Page
Loading...
Need help?
General
