6
Temperature Hair Type
Low Thin/ne, damaged or bleached hair
High Thick and dicult to style hair
Rotation settings
• Only the 30 mm tong and the 40 mm brush rotate.
• To use the rotating function press the right arrow (+) on the rotation switch to rotate
the attachments clockwise and the left arrow (-) to rotate the attachments anti
clockwise.
• NOTE: The brush and tong attachments will only start rotating when a temperature
setting has been selected.
Prepare the hair for styling
• Wash and condition the hair as normal.
• Squeeze out excess moisture with a towel and comb through.
• Using the pre-styling nozzle rough dry the length and roots until 80% dry.
• Divide the hair into sections, style the lower layers rst.
Create volume and shape using the 40mm rotating brush
• To dry your roots and add volume, place the brush underneath the section close to the
roots and hold for a few seconds, lifting the hair as you dry.
• Move the styler downwards through the hair section, at the same time rotate the brush
away from the head by pressing and holding -or + as required.
• Keep moving the styler downwards to resist the brush rotation. Doing this will create
tension through the section of hair.
• If the brush spins too quickly release the rotation switch and remove the brush from
your hair.
• To create shape, continue rotating the brush until you reach the ends of the hair and
then roll the ends under.
• For even more volume, wrap the bottom of the hair section around the brush. Press and
hold the applicable rotation switch (- +) and wind the entire length of the section
around the barrel, stopping at the roots. Release the rotation switch and hold the brush
in the hair for a few seconds or until the section is dry.
• Repeat this around the head.
• Let the hair cool before styling.
• Let the attachment cool before removing.
• Place the protective cover over the brush head to protect the bristles from damage in
storage.
Create loose curls with the 30 mm rotating tong
• Place the end of a section of hair underneath the tong clip.
• Press and hold the applicable rotation switch (- +) and wind the entire length of the
section around the barrel, stopping at the roots.
ENGLISH
To Next Page
Loading...
