Remington BHT250 - Getting Started Guide; Charge Level Indicators; Trimmer Usage Instructions; Changing Trimmer Attachments

4
C GETTING STARTED
• Note: It is recommended to fully charge your appliance before using for the
rst time. Please refer to the charge times shown in this book.
• Ensure the product is switched o.
• Connect the product to the adaptor and then to the mains.
, Charge Level Indicators
Charge Level Indicator
Charging LED will show
Fully Charged LED will show
• Run time from fully charged is up to 60 minutes.
• Charge time from empty is 4 hours.
, Note: To preserve the life of your batteries, let them run out every 6 months
then fully charge.
F INSTRUCTIONS FOR USE
• Switchtheproductonbypressingtheon/offswitch.
• Selectthedesiredtrimlengthpriortotrimmingbyattachingoneofthefixed
combs.
• Iftrimmingforthefirsttime,alwaysstartwiththelongestlengthcomb
(6mm).
• Alwaysensurethetrimmerisswitchedoffbeforeattachingorremovinga
comb.
, CHANGING ATTACHMENTS
• Toattachacomb,placeitontopofthetrimmerwiththeteethofthecomb
over the main trimmer blade. Slide the comb down the grooves until it clicks
into place.
• Toremovethecomb,unclickthesidesofthecombwhereitconnectstothe
trimmer and lift the comb away from the trimmer.
, Note: Using the detail blade side of trimmer with no combs attached will trim
down to 0.2mm. Using the main trimmer blade with no combs attached will
trim hair to 1mm. Holding the main blade perpendicular to the skin will trim
hair to 0.4mm.
ENGLISH