11
12. OPENING SAFE WITH PROGRAMMED SECURITY CODE
13. LOCKED OUT OF YOUR SAFE
In the event you have forgotten the security code your primary action will be to use
your override keys in order to gain access to your safe and follow the Electronic Lock
Security Setup Code instructions, starting at section 10.
If you have lost your backup keys, you will need to contact customer service at the
number below. Proof of purchase is required to obtain keys.
CONTACT CUSTOMER SERVICE AT (888) 792-4264
8
#
1 2 3 4
5
6 7
*
9
0
While the safe door is still open,
confirm your newly entered security
code. Wake up the keypad by
swiping the keypad with your
finger(s). Then enter the 3-8 digit
code followed by the [ # ]. If
successful you will hear two beeps
and the green light will illuminate,
allowing you to retract
the bolts.
Always remember to SWIPE your finger(s) across the surface of the keypad to wake
the keypad in order to enter the keypad codes. Simply touching the keypad may not
trigger a sensor point on the key pad to activate keypad.
Note:
Do not shut the safe door until you have confirmed your new security code
at least 3 times to ensure your code has been saved and you can open the door
successfully. If the code fails, the yellow (left) light will flash and beep. Repeat the
steps above until successful.
WARNING: If the incorrect security code is entered 3 times you will have an automatic
lockout for 30 seconds before you can enter your code again. If 3 additional failed
attempts are made, the keypad will lockout for 5 minutes. Leave batteries in to go
through lockout cycle. If batteries are removed the timer will restart zero.
To Next Page
Loading...