Remington Durablade MB010 - Using with Shaving Gel; Groomer Care and Maintenance; Battery Removal; Recycling Guidelines

5
Trimming with shaving gel
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean
away any excess gel and debris.
CARE OR YOUR GROOMER
To ensure long lasting performance of the groomer, clean after each use.
The easiest and most hygienic way to clean the groomer is by rinsing the head under the
tap after use while the blades are running.
To keep the unit in optimal condition we recommend re-oiling the blades after cleaning.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable battery. Parts of
the shaver case, and tools have sharp edges and may cause injury if not handled
correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure the trimmer is discharged of all power.
2. Remove the comb attachment.
3. Pry o the bottom part below the grips.
4. Press in the exposed tabs and pull the internal frame out.
5. Disconnect the battery from the circuit board and internal frame.
• Used batteries must be removed from the appliance and disposed of at an
appropriate ocial recycling/collection point.
• Do not attempt to operate the shaver once you have opened it.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate ocial recycling/
collection point.