9
C CLEANING AND MAINTENANCE
• To ensure a long lasting performance of your epilator, clean the head
assembly regularly.
, CLEANING THE EPILATION HEAD AFTER EACH USE:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and open the head assembly (Diagram F).
• Turn the head assembly upside down.
• The epilator head can be removed and rinsed for cleaning. For optimal
cleaning, brush hairs from the tweezers before rinsing.
• Although the epilator is suitable for use under running water, it is not
recommended to submerge the unit under water.
, NOTE: Do not completely submerge in water. The epilator head can be
submerged after it has been removed from the epilator body.
, TO REMOVE RESIDUE:
• To remove residue from the stainless steel tweezers, dampen a swab with
alcohol.
• Gently rub the swab over the tweezers until the residue has been removed.
, CAUTION: Make sure the cotton swab is not soaked in alcohol as this may
damage the epilator.
, CLEANING THE SHAVER HEAD AFTER EACH USE:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and remove the shaving head.
• Remove the blade and trimmer assembly by placing your fingers either
side of the assembly pulling upwards.
• Gently shake the blade and trimmer assembly to remove the hair. Use the
cleaning brush to brush the trimmer and shaver housing.
• Replace the blade and trimmer assembly.
, NOTE: Never use the cleaning brush on the foil as damage may occur.
, CLEANING THE PEDICURE HEAD AFTER EACH USE:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and remove the pedicure head.
• To clean, gently brush the roller head with the cleaning brush.
, Note: the Pedicure Head is not washable.
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSIBG HRUAAE
ENGLISH
To Next Page
Loading...
