Remington F5800 - Shaving Instructions; Trimming Functionality; Shaver Maintenance and Care; Cleaning Procedures

4 5
• Theshaveradaptsautomaticallytoamainsvoltagebetween100Vand240V.
C CORDED USE
• Connecttheshavertotheadaptor,thentothemainsandrechargefor5minutes
before using.
A CAUTION
Extended mains only use will result in the reduction of the battery life.
F HOW TO USE
,
SHAVING
• Makesureyourshaverisproperlycharged
• Switchtheshaveron.
• Stretchtheskinwithyourfreehandsothehairsstandupright
• Holdtheshavingheadsothatthefoilstouchyourface
• Useshort,circularstrokes.
, TRIMMING
• Whileyourshaverisswitchedon,slidetheon/oswitchupwardstoactivatethe
trimmer.
• Pushthetrimmerreleasebutton.
• Holdthetrimmeratarightangletoyourskin
• Toretractthetrimmerpushthetoprearofthetrimmerdownwarduntilitlocksunder
the trimmer release button.
E Tips for best results
Ensureyourskinisdry.Alwaysholdtheshaveratrightanglestotheskinsothatallthree
heads are touching the skin with equal pressure.
Usemoderatetoslowstrokingmovements.Theuseofshortcircularmotionsinstubborn
areasmayobtainaclosershave,especiallyalongtheneckandchinline.
DONOTpresshardagainsttheskininordertoavoiddamagetothefoil.
C CARE FOR YOUR SHAVER
•Careforyourappliancetoensurealonglastingperformance.
•Werecommendyoucleanyourapplianceaftereachuse.
•Theeasiestandthemosthygienicwaytocleantheapplianceisbyrinsingtheappliance
head after use with warm water.
•Keepthetrimmerinthe“o”positionwhentheshaverisnotinuse.
C DRY CLEANING
•Ensuretheshaverisswitchedoandunpluggedfromthemainsoutlet.
•Pullthefoilassemblyuptoremovefromhairpocket.
•Thoroughlyblowoutthestubblefromthefoilsandcutters.
•Tapoutexcesshairshavingsanduseacleaningbrushifnecessary.
•Donotcleantheshavingfoilwithabrush.
•Replaceheadassembly.
C WASHABLE CLEANING
•Ensuretheshaverisswitchedoandunpluggedfromthemainsoutlet.
•Pullthefoilassemblyuptoremovefromhairpocket.
•Foils–donotusethebrushtocleanthefoils.Instead,blowtheshavingsoutorrinsethe
foils under cold water or warm water.
•Cutters&Trimmers–Usethecleaningbrushtosweepanyloosehairsfromthecutter
andtrimmer.Rinsethemincoldorwarmwater.Donotusehotwater.
•Aftercleaning,replacetheheadassembly.
•Replaceheadassembly.
A CAUTION
Neversubmergeyourshavercompletelyunderwater.
C TRIMMER
Lubricatetheteethofthetrimmereverysixmonthswithonedropofsewingmachineoil.
, REPLACING THE FOILS & CUTTERS
Toensurethecontinuedhighestqualityperformancefromyourshaver,werecommendthatfoils
and cutters are replaced regularly.
,SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING:
Irritation: As foils get worn, you may experience skin irritation.
Pulling:Asthecutterswear,yourshavemaynotfeelascloseandyoumayfeelyourcutter
pulling your hair.
Wear through: Youmaynoticethatthecuttershavewornthroughthefoils.
,TO REPLACE THE FOIL
• Pullthefoilassemblyuptoremovefromthehairpocket.
• Insertnewfoilassemblyinhairpocketuntilitsnapsintoplace.
,TO REPLACE THE CUTTERS
• Graspcutterbetweenthumbandforengerandpullforward.
• Snapbothnewcutterassembliesintotopofoscillatortips.