Use and
Styling Guide
Models HC5010, HC5015, HC5020, HC5030
Register Your New Product Today!
By registering your new Remington
®
product, you will receive these important benefits:
Proof of Ownership • Product Protection • Product Registration • Special Offers
Register online at: www.RemingtonProducts.com
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance,
basic precautions should always be
observed, including the following.
Read all instructions before using
this appliance.
DANGER
To reduce the risk of electric shock:
■ Do not reach for an appliance that
has fallen into water. Unplug it
immediately.
■ Do not use while bathing or in
the shower.
■ Do not place or drop into water
or other liquid.
■ Do not place or store this appliance
where it can fall or be pulled into a
tub or sink.
■ Always unplug this appliance from
the electrical outlet immediately
after using.
■ Unplug this appliance before
cleaning it.
■ Do not use outdoors or operate
where aerosol (spray) products are
being used, or where oxygen is
being administered.
■ Always store this appliance and
cord in a moisture-free area.
Do not store it in temperatures
exceeding 140°F (60°C).
■ Do not plug or unplug this
appliance when your hands are
wet.
■ Do not use an extension cord
or a voltage converter with this
appliance.
■ Always attach the plug to the
appliance, then to the outlet. To
disconnect, turn all controls to
OFF, then remove plug from outlet.
Detach removable power cords
from appliances for storage.
■ Do not place this appliance on any
surface while operating.
■ This appliance has a polarized plug
(one blade is wider than the other).
As a safety feature, this plug will
fit in a polarized outlet only one
way. If the plug does not fit fully
in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician. Do not attempt to
defeat this safety feature.
■ Do not use this appliance with a
damaged or broken cutting unit,
as injury may occur. Always make
certain blades are aligned properly.
■ This clipper is designed for use
with 120 Volts AC, 60 HZ electrical
outlets. Do not connect the clipper
to a higher voltage than indicated,
as it may result in personal injury
and/or damage to the clipper.
WARNING
To reduce the risk of burns, fire,
electric shock or injury to persons:
■ This appliance is for household
use only.
■ An appliance should never be left
unattended when it’s plugged in.
■ Close supervision is necessary
when this appliance is used by,
on, or near children or persons
with special needs.
■ Use this appliance only for its
intended use as described in this
manual. Do not use attachments
not recommended by Spectrum
Brands, Inc.
■ Keep the cord away from heated
surfaces.
■ Never operate this appliance if it
has a damaged cord or plug, if it is
not working properly, if it has been
dropped or damaged, or if it has
been dropped into water. If any
of these things happen, return
the appliance to a Remington
authorized service center for
examination and repair.
■ Never drop or insert any object into
any of the appliance’s openings.
SAvE ThESE INSTRUCTIONS
Part HC5010 HC5015 HC5020 HC5030
1. Clipper Unit x x x x
2. Style Guide x x x x
3. Blade Guard x x x x
4. Light Texture Comb x
5. Heavy Texture Comb x
6.
#
0 (1.5 mm) Guide Comb x x x
7.
#
1 (3 mm) Guide Comb x x x x
8.
#
2 (6 mm) Guide Comb x x x x
9.
#
3 (9 mm) Guide Comb x x x x
10.
#
4 (12 mm) Guide Comb x x x x
11.
#
5 (16 mm) Guide Comb x x x
12.
#
6 (18 mm) Guide Comb x x x
13.
#
7 (22 mm) Guide Comb x x x
14.
#
8 (25 mm) Guide Comb x x
15.
#
9 (30 mm) Guide Comb x
16. Left Ear Taper x x x x
17. Right Ear Taper x x x x
18. Thin Hair Lifter x x x
19. T-Brush x x x x
20. Neck Brush x x x
21. Nylon Cape x x x
22. Standard Storage Case x
23. Deluxe Storage Case x x
24. Oil Bottle x x
25. Scissors x x x x
26. Barber Comb (7”) x x x
27. Sectioning Clips 2x 4x 4x
Product Features
Thank you for choosing Remington. Your clipper is designed to perform dependably
and efficiently for years helping you to maintain a range of hair styles.
HC5010 HC5020,
HC5030
1
2
HC5015
How to Use
Line Cord Safety Tips
NOTE: This appliance has a polarized
plug (one blade is wider than the
other). As a safety feature, this plug
will fit in a polarized outlet only one
way. If the plug does not fit fully in
the outlet, reverse the plug.
If it still does not fit, contact a quali-
fied electrician. Do not attempt to
defeat this safety feature.
1. To insert plug, grasp it firmly and
guide it into outlet.
2. To disconnect the appliance, grasp
the plug and remove it from outlet.
Do not pull or yank on the cord or
appliance. Do not wrap the cord
around the appliance.
Thin Hair Lifter
The Thin Hair Lifter (item 18), is perfect
for use on thin or curly hair. Additional
teeth help to pickup hairs that may lie
flat, making them difficult to cut. To
use, snap Thin Hair Lifter onto desired
guide comb then use guide comb as
normal.
Removable Blade Assembly
The HC5030 has a removable blade
assembly that allows you to brush out
and rinse the blades under water for
easy cleaning. DO NOT rinse clipper
body in water. Blades can only be
rinsed when they are detached from
clipper body. To remove, grasp blade
assembly firmly in one hand and clip-
per in the other hand, then pull apart.
Rinse blades under running water for
10-15 seconds to remove excess hair
and debris. To reattach blade, align
notch on blade assembly with receiver
on clipper body and simply snap back
into place. DO NOT RINSE CLIPPER
BODY IN WATER.
Taper Lever
The HC5020 and HC5030 include a
Taper Lever. Use the Taper Lever to
add versatility to your hair cuts by
changing the closeness of the blades
gradually. The Taper Lever has 6
length options with the fully forward
position providing the closest cut.
Moving the lever gradually backward
increases the length.
Blade Care
The life of your clippers will depend
on frequency of use, care, hair type,
and condition. The HC5015 and
HC5020 have blades that do not
require additional oiling. To maintain
the HC5010 blades in peak condi-
tion, apply oil after every three to
four haircuts. The HC5030 has a
removable blade assembly that can
be rinsed under water. It is recom-
mended to oil the blades after each
time it is rinsed.
3
4
5
6
7
8
9
10
11
12
13
15
16
17
18
19
20
21 22 23
24
25
26
27
14
To Next Page
Need help?
General
