EasyManua.ls Logo

Remington HC5150 - Post-Use Cleaning; Six-Month Maintenance; Battery Removal

Remington HC5150
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
• Note:Ensuretheclipperisturnedowhencleaning.
, EVERY SIX MONTHS
• Atregularintervalsthebladesetshouldberemovedandcleaned.
• Removethe2screwsretainingthexedbladewithascrewdriver.Donot
remove blade set.
• Brushouthairsfrombetweenthebladeswithsoftcleaningbrush.Donot
remove the lubricating grease from the blades. It is not necessary to remove
the small moving blade from the unit.
• Ifthemovingbladehasbeenremovedthiscanbere-ttedbyslottingthe
blade holder over the pin in the centre of the interior product head. The
groove on the blade, just below the teeth, rests on a metal plate at the
oppositesidetothescrewholes.Thexedbladeisttedwiththeraised
prolepointingoutwardsandxedwiththe2screws.
• Ifthebladesarenotcorrectlyaligned,cuttingeciencywillbeimpaired.
• Placeafewdropsofcutterorsewingmachineoilontotheblades.Wipeo
excess oil.
• Donotuseliquidcleanersonthebladesorharshorcorrosivechemicalson
the blade casing. Always use a soft brush to remove the accumulated hairs.
• Unplugthechargeadaptorfromthepoweroutletwhenttingorremoving
attachments, or while cleaning the product.
• Alwaysstorethisapplianceandcordinamoisture-freearea.
• Donotwrapthecordofthechargingadaptoraroundtheappliance.
BATTERY REMOVAL
• Thebatterymustberemovedfromtheappliancebeforeitisscrapped.
• Theappliancemustbedisconnectedfromthesupplymainswhenremoving
the battery.
• Ensurethattheclipperisdischargedofallpoweranddisconnectedfromthe
mains
• LiftorprytheUSBportcoverplateonthebottomoftheclipper.
• Liftorprythedecoplateonthelowerportionoftheclipperandunscrew1
screw located on the back housing of the clipper.
• Liftorprytheclipperhalvesapart,exposingthebatterychamber.
• Removethebatteryandprintedcircuitboardassemblyfromthebattery
chamber.
• Cutthetabsonbothendsofthebatteryandremoveitfromtheprinted
circuit board.
• Thebatteryistobedisposedofsafely.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA

Other manuals for Remington HC5150

Related product manuals