Remington HC5400 - INSTRUCTIONS FOR USE; Hair Cutting Techniques

6
, TO ATTACH A COMB
• Holdthecombwithitsteethupward.
• Slideitontoandalongtheclipperbladeuntilthefrontofthecombrmlysits
against the clipper blade.
, TO REMOVE THE COMB
• Holdingtheclipperwiththebladesfacingawayfromyou,rmlypushthecomb
upward and away from the blades.
, INSTRUCTIONS FOR CUTTING HAIR
For even cutting, allow the comb attachment/blade to cut its way through
 thehair.Donotforceitthroughquickly.Ifyouarecuttingforthersttime,start
with the maximum comb attachment.
, STEP 1 – Nape of the neck
• Setthecombto3mmor6mm.
• Holdtheclipperwiththebladeteethpointingupwards.Beginstartingatthe
centre of the head at the base of the neck.
• Slowlylifttheclipper,workingupwardsandoutwardsthroughthehair,
trimming just a little at a time.
, STEP 2 – Back of the head
• Withthecombsetat12mmor18mm,cutthehairatthebackofthehead.
, STEP 3 – Side of the head
• Setthecombto3mmor6mm,trimsideburns.Thenchangethesettingto9mm
and continue to cut the top of the head.
, STEP 4 – Top of the head
• Usethelongerlengthcombattachmentandsetitto24mmor27mmthencut
hair on top of the head against the direction in which the hair normally grows.
• Forlongerhairontop,usethelongerlengthcombattachment(24–42mm)to
achieve the desired style.
• Alwaysworkfromthebackofthehead.
, STEP 5 – The nishing touches
• Usetheclipperwithoutanattachmentcombforclosetrimmingaroundthe
base and sides of the neck.
• Toproduceacleanstraightlineatthesideburns,reversethehairclipper.Place
the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
ENGLISH