Remington HC5400 - CARE FOR YOUR HAIRCLIPPER; Cleaning Procedures

7
, SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
• Startingwiththelongestguidecombattached(24-42mm),cutfromtheback
of the neck to the crown. Hold the guide comb at against the head and slowly
move the clipper through the hair.
• Usethesameprocedurefromthelowersidetotheuppersideofthehead.
Then cut the hair against the direction in which it grows and level with the
sides.
• Togivea“attop”look,thehairontopoftheheadmustbecutoverthetopof
a at comb.
• Useacloserguidecombtotaperthehairdowntothenecklineasdesired.
, DUAL BOOST SYSTEM (HC5600)
• Thereare3settingsfortheDualBoostsystem:O,On,Boost.
• Iftheclipperissettoon,itwillrunatregularpower.
• Iftheclipperissettoboost,itwillprovidemaximumpower.
, AUTO BOOST SYSTEM (HC5800)
• Thereare3settingsfortheAutoBoostsystem:O,Auto,Boost
• IftheClipperissettoAuto,itwillrunatregularpowerunderlowload 
conditions.
• Whenmorepowerisneeded,theclipperwillautomaticallysensethisand
provide maximum boost.
• ToactivatetheBoostsetting,depressthepowerbuttonfor2seconds.The
clipper will then constantly run at maximum power.
C CARE FOR YOUR HAIRCLIPPER
Yourclipperisttedwithhighqualityblades.Toensurelonglastingperformance
of your clipper, clean the blades and unit regularly. Always keep the attachment
guide comb on the trimmer blade.
, AFTER EACH USE
• Ensuretheclipperisswitchedoanddisconnectedfromthemainsbefore
cleaning.
• Brushtheaccumulatedhairfromtheblades.Donotsubmergetheclipperin
water.
• Tocleanunit,wipewithdampclothanddryimmediately.
, WASHABLE CLEANING
• TheQUICKWASHSYSTEMisdesignedtomaximisetheeciencyofwashable
cleaning.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSLAE
HR