Remington HC5400 - CARE FOR YOUR HAIRCLIPPER; Six-Monthly Maintenance and Lubrication; General Cleaning Precautions

8
• Pushthebuttonthatislocatedonthefrontofthehairclipper.Thebladeswill
slide out and the blade set can be easily cleaned under the tap.
• Oncethebladesarecleanedthebladesarelockedintoplacebypushingthe
blade set towards the hair clipper head and will snap into place.
• Donotruntheentireunitunderthetap,onlythebladesetismeanttobe
submerged in water.
Note: Ensure the clipper is turned o when cleaning.
, EVERY SIX MONTHS
• Atregularintervalsthebladesetshouldberemovedandcleaned.
• Removethe2screwsretainingthexedbladewithascrewdriver.Donot
remove blade set.
• Brushouthairsfrombetweenthebladeswithsoftcleaningbrush.Donot
remove the lubricating grease from the blades. It is not necessary to remove the
small moving blade from the unit.
• Ifthemovingbladehasbeenremovedthiscanbere-ttedbyslottingthe
coated blade holder over the pin in the centre of the interior product head. The
groove on the coated blade, just below the teeth, rests on a metal plate at the
 oppositesidetothescrewholes.Thexedbladeisttedwiththeraisedprole
 pointingoutwardsandxedwiththe2screws.
• Notethatifthebladesarenotcorrectlyalignedthencuttingeciencywillbe
impaired.
• Placeafewdropsofcutterorsewingmachineoilontotheblades.Wipeo
excess oil.
, CLEANING CAUTIONS
• Ensuretheapplianceisswitchedoandunplugfromthemainoutletbefore
cleaning.
• Onlytheattachmentguidecombsandtrimmerblademayberemovedfrom
the product for cleaning.
• Cleaningshouldbedonewithasoftbrush,suchasthebrushsuppliedwiththe
product.
• Donotrinseunderwater.
• Donotuseharshorcorrosivecleanersontheunitsortheirblades.
ENGLISH