CLEANING & LUBRICATION INSTRUCTIONS
• After each use, hold the shaver over a bin and remove the top of the
shaving head.
• Pull the cutting head unit off the head assembly (fig. A).
• Empty the clippings that have collected inside the hair pocket into the
bin.
• The head can be rinsed under a running tap (fig. B).
• Use a cleaning brush to remove any shaving debris.
• Shake off excess water and allow to dry before reassembly.
• To maintain optimum performance, the blades must be
kept lubricated.
• Apply a very small drop of light oil onto the inside of each separate
cutter head. Hair clipper oil or sewing machine oil are suitable for this
purpose.
• Oil should be applied weekly or if the shaver begins to ‘pulse’
indicating lubrication is required.
(Silicone based pressure pack lubricants are not recommended.)
12
A
B
To Next Page
Loading...
