5
PARTS
1. On/O switch
2. Zoom wheel
3. Length position indicator
4. Indicator light
5. Charging connector
6. Trimmer assembly
7. Adjustable comb
8. Detail trimmer (on back)
9. Adaptor (not shown)
10. Cleaning brush (not shown)
11. EDGEStyler (not shown)
CHARGING YOUR APPLIANCE
Before using your trimmer for the rst time, charge for 4 hours.
1. Ensure the product is switched o.
2. Connect the charging adaptor to the product and then to the mains.
3. The indicator light will come on.
Charge Level Indicator light
While charging Green LED will ash
Fully Charged Green LED will come on
Low Charge Red LED will come on
• Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 4 hours.
• On a full charge, your beard trimmer will run for up to 60 minutes of cordless usage.
CORDED
• Connect the charging adaptor to the product and then to the mains.
• Switch your trimmer on.
• We recommend you let the product charge for a few minutes before using corded.
CAUTION: Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
FITTING THE ADJUSTABLE COMB
• Hold the trimmer in one hand with your thumb rmly on the zoom wheel to prevent
it from turning. Ensure the length position indicator is at 1.
• Slide the comb down the grooves until it clicks into place.
• The comb can only be attached one way.
To Next Page
Loading...
