Remington MB4045 - Specific Trimming Operations; Clipping and Blending Beard Hair; Trimming Sideburn Edges

7
3 Beard hairs sit on your face much lower than at the root compared to stubble.
Therefore, use a comb to lift up the hair you want to remove and identify
where the root is. This section of hair should be located at the middle of your
ear (see fig. 1).
• Startgradingyourbeardhere,upwards.Don’tstartclippingtooloworyou
are going to be taking away supporting hairs lower down.
CLIPPING
4 Lift this section of hair, guide into the adjustable comb and run the clipper
through. Go over a couple of times.
5 Now it’s time to blend. Lower the grade setting on your trimmer to move onto
the next higher section of hair (eg. grade 4 to 3). Go slightly higher than
previous section working upwards (see fig. 2). Again, place hair into the comb
and run the clipper through.
6 Repeat process (eg. grade 3 to 2) - this is fading. Keep moving the process
upwards until you match the grade number on the sides of your head (fig. 3).
7 Trim any protruding hairs with the enclosed scissors.
8 Brush beard through beard with the enclosed beard brush.
9 Add your choice of beard oil/beard wax to your beard.
10 You’re now beard ready to continue to live that bearded lifestyle!
, TRIMMING EDGE OF SIDEBURNS
• Holdthetrimmerwiththetrimmerbladefacingyou.
• Startwithedgeofsideburnandwiththetrimmerbladesrestinglightly
against your skin, use motions towards edge of sideburn line to trim to
desired locations in facial area.
• Shapeasdesired.
Fig. 1
Fig. 3
Fig. 2