5
CHARGING YOUR APPLIANCE
It is recommended to fully charge your appliance before using it for the rst time.
1. Ensure the product is switched o.
2. Connect the product to the USB cable and then to the USB end of the cable to a powered
USB port.
CHARGING INDICATOR LIGHT
Charging Fully charged Battery Low
The light will come on
The light will stay on for 5
minutes then go out.
The light will ash for 5
seconds when there are 5
minutes or less of run time
left
• Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains supply.
• To preserve the life of your batteries, let them run out every 6 months then recharge for 4
hours.
• Run time from fully charged is up to 40 mins.
ATTACHMENTS
TO FIT AND REMOVE ATTACHMENTS (FIG. B)
Ensure that the device is switched o before tting or removing attachments.
• To remove, rotate the attachment anti-clockwise until it unlocks and then lift it o.
• To t, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.
FITTING AND REMOVING STUBBLE COMBS (FIG. C)
To Fit
• Hook the front of the comb over the blade.
• Press the back of the comb down until it clicks into place.
To Remove
• Lift the tab on the back of the comb upwards until it comes free from the blade.
GB
AE
To Next Page
Loading...
