Remington PF7200 - Cleaning and Maintenance; Dry Cleaning Procedure; Replacing Foils and Cutters

5
• Usemoderatetoslowstrokingmovements.Theuseofshortlinearmotions
in stubborn areas may obtain a closer shave, especially along the neck and
chin line.
• DONOTpresshardagainsttheskininordertoavoidirritationanddamage
to the foil heads.
C CLEANING AND MAINTENANCE
• To ensure long lasting performance clean after each use.
• Ensure the appliance is switched o and unplugged from the mains.
, DRY CLEANING
• Pull the foil assembly up to remove from the hair pocket.
• Gently tap out the excess hair shavings and use a cleaning brush to clean
out the hair pocket if necessary.
• Do not use a brush to clean the shaving foils.
• Replace the head assembly.
• Lubricate the teeth of the trimmer every six weeks with a drop of sewing
machine oil.
, REPLACING THE FOILS & CUTTERS
• To ensure continued high quality performance from your shaver, we
recommend the foils and cutters are replaced regularly.
, Signs that your foil/s and cutter/s need replacing
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert the new foil assembly on the hair pocket, press down and click into
place.
, REPLACING THE CUTTERS
• Grasp the cutter between your thumb and forenger and pull upwards.
• Snap the new cutter into the oscillator tip.
, Note: DO NOT press on the cutter ends as this may cause damage.
• Foil and cutters replacement model: SPF-PF72