6
CAUTION: Extended mains (corded) only use will result in the reduction of
the battery life.
HOW TO USE
Before Starting to Cut
1. Inspect the hair clipper making sure that it is free from hair and dirt.
2. Ensure that the hair is thoroughly dry and tangle free.
3. The blades on your hair clipper should be oiled before every haircut.
Lubricating the Hair Clipper Blades
Simply place a few drops of oil on the teeth of the blades. Use only the light grade
oil supplied or a suitable alternative like sewing machine oil. Only this type of oil
is suitable due to the high oscillation speed of the blades on your Remington hair
clipper. Do not use hair oil, grease or any oil mixed with kerosene or any solvent as
the solvent will evaporate and leave the thick oil, slowing the blades.
If oil is not applied to the blades or only a small amount of oil is applied, this may
cause cutting problems. Blades will wear prematurely and not cut properly if they
are not sufficiently lubricated. There may also be a pulling sensation on the hair.
Instructions for Hair Cutting
NOTE: For even cutting, allow the trimmer comb/blade to cut its way through the
hair. Do not force it through quickly. If you are cutting for the first time, start with the
maximum length trimmer comb, until you know how short you would like your hair to be.
NOTE: The comb guide lengths described for use in the steps below are an
example only, if you want a longer or shorter hair cut you will need to adjust the
comb guide lengths to suit your requirements.
Comb Settings
MARK
LENGTH SETTING
Comb 1 - Short Comb 2 - Long
1 3mm 18mm
. 4.5mm 19.5mm
3 6mm 21mm
. 7.5mm 22.5mm
5 9mm 24mm
. 10.5mm 25.5mm
7 12mm 27mm
. 13.5mm 28.5mm
9 15mm 30mm
To Next Page
Loading...
