ABOUT YOUR HAIR CLIPPER
HC7110AU Specifications
Power System Cord/Cordless (Rechargeable)
Initial Charge Time 24 Hours
Full Charge Time 18 – 20 Hours
Run Time 40 Minutes
Indicators Charging
Voltage Type Single
Power System: Cord/Cordless – can be used with or without the power
cord.
Charging Indicator: red light that glows when the hair clipper is being
charged.
Voltage Type: Single – 220-240V only.
CHARGING YOUR HAIR CLIPPER
Cordless Use
• Before using your hair clipper for the first time, charge it for 24 hours.
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
The charging LED light will display on the clipper.
• If the product is not going to be used for an extended period of time
(2-3 months), unplug it from the mains and store.
• Fully recharge your hair clipper when you would like to use it again.
• It is not recommended to use this hair clipper directly from the power
outlet when it has been fully charged, however, while using the hair
clipper in cordless mode if there is a noticeable drop in power, you can
use the hair clipper directly from the power outlet.
• To preserve the life of your batteries, let them run out every six months
then recharge for 24 hours.
Corded Use
• Connect the charging adaptor to the product and then to the mains.
• When the cord is connected to the mains, a charging LED light is
displayed on the hair clipper.
Caution: Extended mains (corded) only use will result in the reduction of
the battery life.
5
To Next Page
Loading...
