6
• The digital display window will light up, and the temperature setting will
default to 190°C. The blue back light on the digital display window and
the bars in the right of the digital display window will flash while the plates
are heating to the temperature selected. When the temperature selected
has been reached, the blue back light on the digital display window and
the bars on the right of the window will be steady.
• To select a higher temperature press the '+' temperature increase button.
To select a lower temperature press the '-' temperature decrease button.
The temperatures will increase or decrease in 10°C steps.
• The temperatures that can be selected are:
150ºC, 160ºC, 170ºC – a short bar will be displayed in the right hand
corner of the digital display window.
180ºC, 190ºC, 200ºC – 2 bars will be displayed in the right hand corner
of the digital display window.
210ºC, 220ºC, 230ºC – 3 bars will be displayed in the right hand corner
of the digital display window.
The straightener will be ready to use in 15 seconds depending on the
temperature selected.
• Holding down the '+' button for 2 seconds will activate the turbo boost
function, and will automatically select the highest temperature at 230°C.
Holding down the '-' button for 2 seconds will activate the temperature lock
function. Use this to avoid accidentally altering the temperature during use.
• Take extra care when using the straightener, as it can get very hot. It is
important to establish the correct temperature for your hair type prior to
use, to prevent over drying or damage to your hair. If in doubt, start with
the low temperature setting first, and increase the temperature gradually
by pressing the '+' temperature increase button
• To switch your straightener off, press and hold the on/off switch for 2
seconds.
To Straighten Your Hair
• To make styling easier, part the hair either in the middle or to the side and
use clips to section your hair, top, sides and back.
• You may need to comb through your hair before straightening to ensure
that it is tangle free.
• Start at the nape of the neck and straighten the underneath sections of
hair first. When the underneath sections of hair are complete, move to the
next layers, finishing with the hair around the part line.
• Take about a 5 cm section of hair and pull taut, and down and away from
the scalp. Holding the straightener with the other hand, start at the roots
and clamp the hair firmly between the plates.
To Next Page
Loading...
