4
• Keep the power plug and cord away from heated surfaces.
• Do not leave the appliance unattended while plugged in.
• Do not place the appliance on any soft furnishings.
• Do not use attachments other than those we supply.
• Do not set the appliance down while still on.
• Do not twist or kink the cable, or wrap it round the appliance.
• Do not use the appliance if it is damaged or malfunctions.
• Check the cord regularly for any sign damage.
• Always keep the lid closed while the rollers are heating.
• Ensure there is a roller on each slot while the unit is heating and that each roller is
properly inserted into the base unit.
• DO NOT USE ON ARTIFICIAL HAIRPIECES OR WIGS.
• This appliance is not intended for commercial or salon use.
PARTS
1. Velvety ocked rollers
8 x medium 25mm
12 x large 32mm
2. Ceramic heated hinged clips
3. Cool touch ends
4. On indicator light
5. Base unit
INSTRUCTIONS FOR USE
• Before use, ensure the hair is clean, dry and tangle-free.
• For extra protection use a heat protection spray.
• Hairsprays contain ammable material - do not use while using this product.
• Section the hair prior to styling. Style the lower layers rst.
• Plug the product into the mains power supply.
• The on indicator light will glow once plugged in indicating that the rollers are on.
• CAUTION: the appliance will begin to heat-up as soon as the power supply is
switched on.
• The lid should remain closed until the rollers are ready to use.
• Rollers will be ready in approximately 90 seconds. Allow 3 to 5 minutes for best
results.
• When you feel your setters are ready, open the lid for 1 minute and begin use.
TO CURL
1. Starting with the lower sections of hair, take a section the width of a roller.
2. Start by using the medium sized rollers. Slide the roller up out of the base unit using
the clip.
3. Remove the clip from the roller.
To Next Page
Loading...
