Remington PROluxe You S9880 - StyleAdapt Mode; Manual Mode

5
1. Plug your styler into the mains power supply.
2. Press the on (C) button to switch on.
3. When it is ready to use, your styler will beep three times and the display will stop
ashing.
StyleAdapt Mode
1. When rst switched on your styler will be in StyleAdapt™ mode 1. The StyleAdapt™
indicator will be fully lit up and StyleAdapt 1 will be shown on the display.
2. Working on one section at a time, run your styler through the entire length of your
hair without stopping.
3. After each pass through your hair, the StyleAdapt™ indicator will spin (g. A)
indicating that your styler is learning about your hair and adjusting the plate
temperature to a heat that is personalised to you. The temperature changes are not
shown on the display but happen quickly and automatically during styling.
• If you are sharing your styler select StyleAdapt™ mode 2. This ensures that when the
styler is used by someone else, it doesn’t change what it has learned about your hair.
To select, press the K button until StyleAdapt 2 is shown on the display.
Manual Mode
1. To override the StyleAdapt™ mode and use as a standard styler, press the K button
several times until the display shows the temperture (e.g. 160ºC) and the
StyleAdapt™ indicator goes o. Note that in manual mode, your styler will no longer
be learning about your hair and adapting the heat.
2. Select the appropriate temperature for your hair using the controls on the side of the
product. Start styling on the lower temperatures rst.
3. The ‘+’ button will increase the temperature, the ‘-‘ button will decrease the
temperature.
Recommended Temperatures
Temperature Hair type
150°C - 170°C Thin / ne, damaged or bleached hair
180°C - 200°C Normal, healthy hair
210°C - 230°C Thick, very curly and dicult to style hair
Caution: the hottest temperatures should only be used by experienced stylers
5. Working on one section at a time, run the straightener through the entire length of
the hair without stopping.
6. To re-activate StyleAdapt™ mode press the K button until StyleAdapt 1 is shown on
the display and the StyleAdapt™ indicator is illuminated. Your styler will now be
learning about your hair and adapting the heat again.