6
INSTRUCTIONS FOR CUTTING HAIR
• To turn the product On or O slide the switch. To locate the On/O switch please refer
to the key features section.
• For even cutting, allow the comb attachment/blade to cut its way through the hair. Do
not force it through quickly. If you are cutting for the rst time, start with the maximum
comb attachment.
STEP 1 – Nape of the neck
• Set the comb to 3mm or 6mm.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – Back of the head
• With the comb set at 12mm or 18mm, cut the hair at the back of the head.
STEP 3 – Side of the head
• With the comb set at 3mm or 6mm, trim sideburns. Then change to the longer 9mm
guide comb and continue to cut the top of the head.
STEP 4 – Top of the head
• Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on
top of the head against the direction in which the hair normally grows.
• For longer hair on top, use the longer length comb attachment (24 – 44mm) to achieve
the desired style.
• Always work from the back of the head.
STEP 5 – The nishing touches
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper.
• Place the reversed clipper at right angles to the head, tips of the blades lightly touching
the skin and then work downwards.
DUAL BOOST SYSTEM (HC7151)
• There is a 3 position switch on HC7151 only. First position is O, second is normal speed,
and 3 position is Boost for extra power to cut through thicker hair.
• If the clipper is set to On, it will run at regular power.
• If the clipper is set to Boost, it will provide maximum power.
CARE FOR YOUR HAIRCLIPPER
• Your clipper is tted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit regularly.
• Always keep the attachment guide comb on the trimmer blade.
ENGLISH
To Next Page
Loading...
