27B
All information contained on this sheet is the property of Remote King PTY LTD. Unauthorised use or reproduction is prohibited.
RCG12C - GARAGE
REMOTE PROGRAMMING
The following procedure is for programming a RCG12C remote to your garage door:
Or
Press and hold the same
button again for 2 seconds.
Release the ‘Door Code’
button. Your new remote is
now programmed.
Press and hold the ‘Door
Code’ button on the reciev
er board. Continue holding
through steps 3, 4 & 5.
Press and hold a transmitter
button on your new
remote for 2 seconds.
Release the button for 2
seconds.
1 2
6
3
4 5
RCG12C
1
Identify your roller door motor.
If necessary remove the light
cover to reveal the Control
Panel.
Identify your sectional door
motor. On the motor locate
the Control Panel.
To Next Page
Loading...