RemotePoint Presenter Global User Manual

FCC Certication
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a CLASS B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses, can radiate radio frequency energy and if not
installed and used in accordance with the instruction guide, may cause harmful interference to
radio communications. However, there is no guarantee that this radio interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user is encouraged
to try to correct the interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Consult the dealer or an experienced Radio-TV technician for help.
Notice: Any changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. Extension cables are not
recommended, if used, they must be shielded in order to comply with the emission limits.
IC Certication
The term “IC” before the certication/registration number only signies that the Industry Canada
technical specications were met.
Declaration of conformity
Manufacturer: SMK-Link Electronics Corporation
3601-B Calle Tecate
Camarillo, CA 93012
Hereby, SMK-Link. declares that the VP4350 is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
EMC/EMI/Safety Standards:
EN 300 440-2 V1.1.1 (2001-09)
EN 301 489-1 V1.4.1 (2002-08)
EN 301 489-3 V1.4.1 (2002-08)
EN 60825-1 (1994, A11:1996, A2:2001)
Users Manual
VP4350/VP4360
Thank you for purchasing a VP4350 Global Presenter. We
know you had other choices and we appreciate that you
chose Interlink Electronics by SMK-Link for your wireless
needs. So that we may better serve you in the future, please
register online at
www.smklink.com/register.
Thank You
WarranTY
Two Year, Limited Warranty
SupporT
SMK-Link Electronics Corporation
3601-B Calle Tecate
Camarillo, CA 93012
TEL: (888) 696-3500
FAX: (805) 987-6665
CLASS IIIaII LASER PRODUCT
LASER RADIATION – DO NOT
STARE INTO BEAM
WAVE LENGTH: 635nm
MAX OUTPUT : <4.5mW

RemotePoint Presenter Global Specifications

General

Brand	RemotePoint
Model	Presenter Global
Category	Digital Presenters
Language	English

Summary

First Use and Initial Setup

Initial Setup and Installation

Guide to installing batteries, connecting the receiver, and initializing the Global Presenter device.

Changing the Blank Key Code

Blank Key Code Configuration

Instructions for changing the key code to blank the screen during presentations, involving receiver setup.

Global Presenter Setup and Operation

Global Presenter Setup

Information on initial factory setup and troubleshooting interference with multiple devices.

Receiver Training Procedure

Steps to train the receiver to accept the digital code from the remote by reconnecting the USB receiver.

Channel Selection and Configuration

Procedure to change the remote's channel by holding the previous button and confirming with the next button.

Global Presenter Controls Overview

Remote Control Functions

Overview of the Global Presenter's buttons and their functions: Laser, Mouse Control, Slides, and Mouse buttons.

Post-Purchase Information

Customer Appreciation and Registration

Thank you message, appreciation for purchase, and instructions to register the product online.

Product Warranty Information

Details on the warranty coverage provided for the Global Presenter, specifying a two-year limited term.

Customer Support Contact Details

Contact information for SMK-Link Electronics Corporation, including address, telephone, and fax numbers.

Regulatory Compliance

FCC Compliance Statement

Information regarding the device's compliance with Part 15 of the FCC Rules and potential interference.

Industry Canada Certification

Explanation of the 'IC' certification term, signifying compliance with Industry Canada technical specifications.

Declaration of Conformity and Standards

Manufacturer's declaration of compliance with EU directives and relevant EMC/EMI/Safety standards.