Renault 2009 CLIO - REAR BENCH SEAT: functions (1;2)

rear bench seat.....................................(up to the end of the DU)
rear seats
functions .........................................(up to the end of the DU)
3.30
ENG_UD10581_1
Banquette arrière : fonctionnalités (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
Jaune Noir Noir texte
Then lift up the rear section of
cushion 1 and tilt the seat base so that
it is next to the front seats.
To fold down the seatback
Remove the rear headrests (if
fitted).
Ensure that the front seats are far
enough forward.
Place the seat belts in their guides
B.
Press button 2 and lower the seat-
back
C.
Rear bench seat: functions
Before moving the seatback, put
the seat belt in belt guide B to avoid
damaging it.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
The configuration of the two seat
bench with the small seatback C
pulled down, does not allow the
central seat to be used as it would
be impossible to buckle the seat belt
(belt buckles inaccessible).
The seat base and the seatback may
be folded down (one or both sections)
to allow bulky objects to be carried.
Start by folding down the seat base,
then the seatback.
To fold away the seat base
Lift up the front of the seat cushion A
until it reaches the stop.
Where the bench seat is in one section,
check that the two sides of the seat
base are correctly locked.
REAR BENCH SEAT: functions (1/2)
A
1
C
B
2