Varying the limit speed
The limit speed may be changed by
pressing repeatedly or holding down:
– switch 2 (+) to increase the speed;
– switch 3 (-) to decrease the speed.
The system is designed in such a
way that it is possible to detect a dif-
ference between the stored speed
and the speed shown on the instru-
ment panel.
Driving
When a limit speed has been stored,
if this speed is not reached the vehicle
behaves in a similar way to those with-
out the speed limiter function.
From this point, no effort on the accel-
erator pedal will allow you to exceed
the programmed speed except in an
emergency (refer to information on
“Exceeding the limit speed”).
Switching on
Press switch 1 on the side showing
Ð. This indicator light on the instru-
ment panel comes on.
Limiting the speed
At a steady speed (above 20 mph
(30 km/ h)), press switch 2 (+): the
speed is stored.
CRUISE CONTROL/SPEED LIMITER: speed limiter function (2/3)
The speed limiter function is
in no way linked to the brak-
ing system.
2 3
1
To Next Page
Loading...
