headrest................................................(up to the end of the DU)
adjusting your driving position ..............(up to the end of the DU)
The headrest is a safety
component; check that it is
fitted and in the correct po-
sition. The top of the head-
rest should be as close as possible
to the top of the head.
To remove the headrest
Press button A of lock 1 and remove
the headrest.
To refit the headrest
Insert the rods into the holes, press the
tabs on both rods and lower the head-
rest.
Positions for use
While pressing button A of lock 1, lift
the headrest fully to use it in the top po-
sition. Lower it until it locks to use it in
the bottom position.
Storage position
Press button A and lower the headrest
completely.
When the headrest is set at the
lowest position, this is for storage
only. It should not be in this position
when a seat is occupied.
REAR HEAD RESTS
1
A
To Next Page
Loading...
