Make sure that no-one has
their fingers close to the
cable when you move the
handle: risk of injury.
PUNCTURE, EMERGENCY SPARE WHEEL (3/4)
To refit a wheel
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its own, unwind it again as follows:
– pull the handle to unwind the cable;
– press the button located under
handle 6 to hold the unwound cable,
then guide it down;
– recover the cable from underneath
the vehicle.
You may refit the wheel.
Position yourself behind the vehicle and
pull handle 6 to raise the wheel until it is
anchored under the vehicle.
After changing a wheel, position the
replaced wheel on support 9, with the
valve facing the ground. Clip cable 7 in
its housing 8 then push the wheel under
the luggage compartment.
Ensure that tab 10 is positioned to-
wards the rear of the vehicle.
6
7
8
9
10
To Next Page
Loading...
