TYRE PRESSURE KIT (2/3)
Depending on the vehicle, in the event
of a puncture, use the kit located under-
neath the luggage compartment carpet.
Open the kit, remove the caps 1 and 4
(it is essential not to remove the burst-
ing disc from the bottle) and screw
bottle 2 in place of cap 4.
With the engine running and the
parking brake applied,
– unscrew the valve cap of the wheel
concerned and screw on the inflation
adapter 6;
– adapter 8 must be connected to ve-
hicle accessories socket 9;
– press switch 3 to inflate the tyre to
the recommended pressure (refer to
the information on “Tyre pressure”);
– after a maximum of 5 minutes, stop
inflating and read the pressure (on
pressure gauge 5).
Note: while the bottle is emptying (ap-
proximately 30 seconds), the pressure
gauge 5 will indicate briefly a pressure
of 6 bar, then the pressure drops.
1
3
4
5
6
7
8
9
Before using this kit, park
the vehicle at a sufficient
distance from traffic, switch
on the hazard warning
lights, apply the handbrake, ask all
passengers to leave the vehicle and
keep them away from traffic.
2
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation apply-
ing to the country you are in.
To Next Page
Loading...
