Renault 2013 Clio - Starting;Stopping the Engine Using the Key

engine start/stop button ........................(up to the end of the DU)
ignition switch .......................................(up to the end of the DU)
starting the engine ................................(up to the end of the DU)
starting the engine ................................(up to the end of the DU)
switching on the vehicle ignition ...........(up to the end of the DU)
2.3
ENG_UD25390_2
Contacteur de démarrage : véhicule avec clé / télécommande à radiofréquence (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-7_BCSK85_Renault_2
Ignition switch
Special note on vehicles with an au-
tomatic gearbox
Before starting, move the lever to posi-
tion N or P.
Special note on vehicles with a
Quickshift gearbox
Depress the brake pedal with the lever
in the N position.
Note:
If a gear other than neutral is displayed,
it flashes; starting is not possible unless
you depress the brake pedal, while
holding the key in the starting position.
Ignition position M.
The ignition is switched on:
Start position D
If the engine fails to start at the first
attempt, the key must be turned back
before the starter can be activated
again. Release the key as soon as the
engine starts.
Note: on diesel versions, several sec-
onds may pass between turning the
key and the engine starting to allow for
engine preheating.
Off position S (steering lock
applied)
To lock: remove the key and turn the
steering wheel until the steering column
locks.
To unlock: turn the key and the steering
wheel slightly.
“Accessories” position A
When the ignition is switched off, any
accessories (radio, etc.) will continue to
function.
IGNITION SWITCH: vehicle with key