STARTING, STOPPING THE ENGINE - VEHICLE WITH CARD
3
|
92 - Driving
The card must be in detection zone
1
.
To start :
– vehicles with an automatic gearbox,
place the lever in position N, press
brake pedal and press button
2
;
– vehicles with a manual gearbox, de-
press the brake or clutch pedal and
press the button
2
. If a gear is en-
gaged, the vehicle may only be started
by depressing the clutch pedal.
Special features
– If one of starting conditions is not ap-
plied, the message “BRAKE + START”
or “CLUTCH + START” or “Select
“NEUTRAL” is displayed on the instru-
ment panel ;
– in some cases, it will be necessary
to move the steering wheel whilst
pressing the start button
2
to help un-
lock the steering column ; the mes-
sage “TURN+ START” will warn you of
this ;
Starting with tail gate open in
hands-free mode.
In this case, hands free card must not
be located in the luggage compart-
ment.
Never switch off the ig
nition before the vehi
cle has stopped com
pletely. Once the engine
has stopped, the brake servo,
power assisted steering and pas-
sive safety equipment such as air
bags will no longer operate.
The steering is locked when the
key is removed.
Accessories function
(switching on the ignition)
To Next Page
Loading...
