driving ...................................................(up to the end of the DU)
4 wheel drive (4WD) .............................(up to the end of the DU)
all-wheel drive system ..........................(up to the end of the DU)
2.21
ENG_UD17458_4
4 roues motrices : 4WD (X45 - H45 - Renault)ENG_NU_830-5_H45_Renault_2
All-wheel drive system: 4 drive wheels (4WD)
ALL-WHEEL DRIVE SYSTEM: 4 wheel drive (4WD) (1/3)
“AUTO" mode
This is the mode defined each time
the engine is started.
Operating principle
The “AUTO" mode automatically dis-
tributes the torque between the front
and rear axles according to the road
conditions and the vehicle speed. This
position optimises roadholding. Use
this mode where the roads are slippery
or in good condition.
“2WD" mode
Press on the upper section of button 1.
The ‘ indicator light will light up on
the instrument panel.
Operating principle
The “2WD" mode uses the front wheels
only. Use this mode where the roads
are in good condition.
To deactivate this mode, press the
upper section of button 1 again. The in-
dicator light on the instrument panel will
go out.
“4WD Lock" mode
Press the bottom section of button 1.
The button returns immediately to its
original position. The ’ indica-
tor light will light up on the instrument
panel.
To deactivate this mode, press the
lower section of button 1 again. The in-
dicator light on the instrument panel will
go out.
Operating principle
The “4WD Lock" mode uses the front
and rear axles, each with 50% of the
power. Use this mode on uneven and
unsurfaced roads.
Note: if the vehicle speed exceeds 24
mph (40 km/h) in “4WD Lock” mode,
the system automatically switches back
to “AUTO” mode.
Driving mode switch 1
Depending on the road conditions,
pressing button
1 enables the following
modes to be selected:
– AUTO ;
– 2WD ;
– 4WD Lock.
1
To Next Page
Loading...
