Indicator lights 3 and } go out a
few seconds after the engine has been
switched off.
Note: if the driver’s door is opened, in-
dicator lights
3 and } will light up
again. They will go out when the door
is closed.
Warning:
if one of the doors is open
but the parking brake has not been ap-
plied, a bleep sounds and the message
“apply parking brake” is displayed on
the instrument panel.
In this case, the vehicle must be im-
mobilised by pulling then releasing the
switch
2.
The parking brake is released as soon
as the vehicle is driven.
Electronic parking brake
ELECTRONIC PARKING BRAKE (1/4)
Automatic releasing of the
electronic parking brake
The brake will be released as soon as
the vehicle starts and accelerates.
Manual operation
Applying the parking brake
Pull then release the switch
2. The
} indicator light lights up on the
instrument panel accompanied by the
message “parking brake applied” and
the
3 indicator light.
Releasing the parking brake
With the ignition on and while depress-
ing the brake pedal, press switch
2
until indicator lights
3 on the switch 2
and
} on the instrument panel go
out.
Dynamic braking
In an emergency, under exceptional
circumstances, switch 2 can be pulled
to stop the vehicle. Beyond a threshold,
the } and © indicator lights
come on. Consult an approved Dealer.
Before leaving the vehicle,
check that the electronic
parking brake is fully ap-
plied.
The } indicator light lights up
on the instrument panel accompa-
nied by the message “parking brake
applied”.
Automatic operation
The electronic parking brake ensures
vehicle immobilisation when the engine
is stopped and engine Start/Stop
button 1 is pressed.
For certain country-specific model ver-
sions, the automatic brake application
function is not activated. Refer to the in-
formation on “Manual operation”.
To confirm that the electronic parking
brake is applied, the message “parking
brake applied” and indicator light }
on the instrument panel and indicator
light
3 on switch 2 light up.
2
1
3
To Next Page
Loading...
